開合式直流漏電流傳感器 YMD1K 系列
Split Core DC leakge current Sensor YMD1K SERIES
可供應的型號有： YMD1K-10MA YMD1K-20MA
技術參數Electrical Data
型號Type 產品技術服務 138 8388 5607 | YMD1K | ||
原邊額定輸入電流 Rated input IPN | 10 | 20 | mA |
原邊電流測量范圍Measure range IP | 0~±20 | 0~±40 | mA |
副邊額定輸出電壓Rated output | DC ±5V,4-20mA,0-20mA (±3%) | V | |
電源電壓Supply Voltage VCC | DC ±12V~±15V (±5%) | V | |
電流消耗Current consumption IC | <20 | mA | |
絕緣電壓Galvanic isolation Vd | 2.5KV /50Hz/1min | ||
線性度Linearity εL | <1 | %FS | |
零點失調電壓Offset Voltage V0 | TA =25℃ <±500 | mV | |
零點失調電壓溫漂Offset Voltage drift VOT | IP=0 TA =-10～+60℃ <±6 | mV/℃ | |
工作環境溫度Operating temperature TA | -10～+60 | ℃ | |
貯存環境溫度Storage temperature TS | -20～+70 | ℃ | |
負載電阻Load resistance RL | ≥10K | Ω | |
外形尺寸（mm）Dimension
使用說明Directions for use
1、錯誤的接線可能導致傳感器損壞。傳感器通電后，當被測電流從傳感器箭頭方向穿過，即可在輸出端測得同相電壓值。
The wrong wiring may lead to damage of sensors, after the power supply when the electric current to be measured through the sensor direction arrow, can be measured at the output end in phase voltage valu
2、傳感器的輸出幅度可根據用戶需求進行適當?shù)恼{(diào)節。
The output of the sensor amplitude can be adjusted as appropriate to the user requirements.
3、在安裝過程中，傳感器打開后，合上時要注意兩邊鐵芯接口是否對齊，不能強行合上。
During the installation process, on the sensor, close attention should be paid to side core interface is aligned, not forcibly closed
