項目

Item

內容

Contents

注意

Notes

高溫保存

High temperature preservation

(1)溫度85℃,放置240小時；(2)室溫放置24小時以上；(3)然后測量以下

項目：不可有結露

(1) Store at 85℃for 240 hours; (2) Keep at a room temperature for more than 24 hours; and (3) Measure (satisfy) the following items: no dew condensation

端子間阻抗：參照電氣特性欄Resistance between terminals: see electrical property item;直線性：參照電氣特性欄Linearity: see electrical property item;絕緣阻抗：參照電氣特性欄Insulation resistance: see electrical property item.

低溫保存

Low Temperature

preservation

(1)溫度-30℃,放置240小時；(2)室溫放置24小時以上；(3)然后測量以下

項目：不可有結露

(1) Store at-30℃for 240 hours; (2) Keep at a room temperature for more than 24 hours; and (3) Measure (satisfy) the following items: no dew condensation

端子間阻抗：參照電氣特性欄Resistance between terminals: see electrical property item;直線性：參照電氣特性欄Linearity: see electrical property item;絕緣阻抗：參照電氣特性欄Insulation resistance: see electrical property item.

高溫高濕保存

High Temperature

& high humidity

(1)溫度80℃濕度90%,放置240小時；(2)室溫放置24小時以上；(3)然后測量以下項目：不可有結露

(1) Store at 80℃and 90% RH for 240 hours; (2) Keep at a room temperature for more than 24 hours; and (3) Measure (satisfy) the following items: no dew condensation

端子間阻抗：參照電氣特性欄Resistance between terminals: see electrical property item;直線性：參照電氣特性欄Linearity: see electrical property item;絕緣阻抗：參照電氣特性欄Insulation resistance: see electrical property item.

冷熱沖擊測試

Heat shook test

(1)-30℃（60分）→70℃（60分）共10次循環；(2)室溫放置24小時以上；(3)然后測量以下項目：不可有結露

(1) -30℃(60min)→70℃(60min) total 10 cycles, (2) Keep at the room temperature for more than 24 hours; and (3) Measure (satisfy) the following items: no dew condensation

端子間阻抗：參照電氣特性欄Resistance between terminals: see electrical property item;直線性：參照電氣特性欄Linearity: see electrical property item;絕緣阻抗：參照電氣特性欄Insulation resistance: see electrical property item.

項目

Item

內容

Contents

注意

Notes

耐敲擊

Hitting Durability

(1)使用Placental(POM)鉛筆(R0.8)敲擊100萬次。(2)然后測量以下項目：

(1) Hit 1,000,000 times with a Placenta (POM) pencil (R0.8); and (2) Measure (satisfy) the following items:

荷重：2N Load:2N

速度：2次/ Sec Speed: 2times/sec

端子間阻抗：參照電氣特性欄Resistance between terminals: see electrical property item;直線性：參照電氣特性欄Linearity: see electrical property item;絕緣阻抗：參照電氣特性欄Insulation resistance: see electrical property item.

耐久劃線

Sliding Durability

(1)使用Placental(POM)鉛筆(R0.8)在AA區域邊緣內縮3mm往復劃線性

10萬次；(2)然后測量以下項目：

(1) Shuttle 100,000 times with a placenta (POM) pencil (R0.8) shrinks 3mm from the AA verge; and (2) Measure (satisfy) the following items:

荷重：2N Load: 2N

速度：100mm / Sec Speed: 100mm/Sec

端子間阻抗：參照電氣特性欄Resistance between terminals: see electrical property item;直線性：參照電氣特性欄Linearity: see electrical property item;絕緣阻抗：參照電氣特性欄Insulation resistance: see electrical property item.

FPC彎曲

FPC Bending

Durability

(1)在FPC末端附上100g力；(2)接著以附著力的部分作不彎曲中心(各彎

曲180度5回)。結果應該滿足以下幾項：

(1) Attach a 100g weight to the end of FPC; (2) Bend the FPC at the angle

Of±180°each for the 5 times, with the FPC adhered portion as the center of bending movement.

The result shall satisfy the following:

端子間阻抗：參照電氣特性欄Resistance between terminals: see electrical property item;直線性：參照電氣特性欄Linearity: see electrical property item;絕緣阻抗：參照電氣特性欄Insulation resistance: see electrical property item.

FPC拉力測試

FPC Heat Seal

Peeling Testing

(1)垂直90°方向：500g力5分鐘；不可剝離；應滿足以下幾項：

端子間阻抗：參照電氣特性欄；

Vertically 90°direction: After 0.5Kg 5min there is not peeling;

The result shall satisfy following items:

(2)水平180°方向：500g力10分鐘；不可剝離；應滿足以下幾項目：

端子間阻抗：參照電氣特性欄；

Horizontal 180°direction: After 0.5Kg 10min there is not peeling;

The result shall satisfy following items:

Resistance between terminals: see electrical property item

FPC耐彎曲性

FPC pattern

Bending

resistance

彎曲半徑為7mm，拉伸長度=25mm，速度為1500rpm；彎曲次數為10

萬次，就滿足以下幾項目：參照電氣特性欄；

Bending 100,000 times by radius 7mm, length of peeling stroke 25mm, Speed 1500rpm; the result shall satisfy following items:

Resistance between terminals: see electrical property item

金手指處焊接性

Gold-finger sold

heat

溫度：235+/-5℃；時間：3-5秒：焊點光滑圓潤

Temperature: 235+/-5℃; Time: 3 – 5 sec, sold-dot smooth surface