產品分類 更多>>
1.描述
Cobar 94Q-MB助焊劑無鹵素(環保) 、固態含量低、低殘留焊后免清洗、酸值偏低（對板子，焊點沒有腐蝕）。這款產品是博世集團在全球所屬公司的一款助焊劑，配方悠久、活性極強、對消除錫球更具有特效.
2.應用
Spray fluxing is the preferred application to apply this flux. Make sure that the unit has a stable and uniform spray-cone.
The flux should have the finest droplets at the lowest possible setting for the atomizing air pressure. (Low air pressure give
bigger and unstable droplets; high air pressure cause bouncing effects of the flux against the PCB surface).
Use a scrap/bare board to set-up the spray parameters. Turn the board upside down after spraying for inspection. It is
essential that a continuous, uniform spray pattern has been deposited all across the board.
