設備輔熱用管道加熱器

工作原理The working principle of

管道電加熱器采用數顯溫度調節儀、固態繼電器和測溫元件組成測量、調節、控制回路，在電加熱過程中測溫元件將管道電加熱器出口溫度電信號送至數顯溫度調節儀進行放大，比較后顯示測量溫度值，同時輸出信號到固態繼電器輸入端，從而控制加熱器，使控制柜具有良好的控制精度和調節特性。利用聯鎖裝置可遠距離啟動、關閉管道電加熱器。

Tube electric heater adopts digital display temperature control instrument, solid state relay and temperature measuring element composition measurement, adjustment, control circuit, temperature measurement in the process of electric heating element will pipe outlet temperature of the electric heater electrical signals sent to the digital display temperature control instrument of amplification, after comparing measured temperature value, at the same time the output signal to the solid state relay input, so as to control the heater, the controller has good control precision and regulating characteristics. Using interlocking device can be remotely activated, closed tube electric heater.

使用前首先檢查電源線、測溫元件輸出連線正確，控制柜元器件、螺母松動損壞，如有異常及時擰緊或更換，確認無誤后可通電試車。主要步驟如下：

1、合上水管道開關，電源指示燈亮，數顯表控制燈亮并顯示所測溫度指示值。

2、溫度設定好之后，如無異常情況即可按下“加熱器工作”按鈕，交流接觸器吸合，固態繼電器進線端得電，由數顯控溫表所輸出PID信號控制加熱器工作。初次開機時，可能出現溫度過沖現象，但逐漸趨向恒定范圍之內。

Before use, first check the power cord, temperature measuring element output connection is correct, control cabinet components, loose nut whether damaged, if there are any abnormal tighten or replace, can electrify test when confirmed. The main steps are as follows:

1, sheung shui pipeline switch, the power indicator lights, digital display to control table indicating lights and display the measured temperature values.

2,